SmokeMonster

Retro-Access MiSTer SCART Cable

The MiSTer FPGA Multi-Console IO board add-on allows for zero-latency analog video output via a Dsub-15 port. This port can be used for virtually any analog signal (component, VGA, etc) including RGB.

While you could use a cheap, modified VGA-to-SCART cable, they are far from ideal in a lot of ways. To answer the demand for a high-quality SCART solution, Retro-Access has launched a custom cable tailored to MiSTer, priced currently at $42. Get it here.

This same cable could be made with BNC leads as well.

Retro-Access MiSTer SCART Cable Features

  • Cabling – Cable Length:
    6 Ft (9)
  • Source Connector – Video Connector:
    15 Pin Dsub (15)
  • Source Connector – 15 Pin Dsub Pinout:
    RGBS
  • Source Connector – Pinout Notes:
    VGA pin 9 is +5v attenuated with a 470 Ohm resistor. This is a cable for the MiSTer IO board. RGB are standard vga pinout and CS uses the H.Sync pin.
  • Source Connector – Audio Connector:
    3.5mm Straight Plug (4)
  • Destination Pinout and Audio – Destination Pinout:
    SCART
  • Destination Pinout and Audio – Destination Audio Connector:
    Audio Line in SCART
     

    #MiSTer, #scart, #retroaccess, #rgb

Liked it? Take a second to support SmokeMonster on Patreon!